Graduate Profile. • Material Engine oil WSS-M2C153-H Silicone gasket and F6AZ-19562-AA or equivalent Ford specification WSE- sealant M4G323-A6 CAUTION: Do not use abrasive grinding discs to remove the gasket material; use only plastic manual scrapers. Do not scratch or gouge aluminium sealing surfaces. • 2002 Focus Workshop Manual Page 2 of 9 5. Install the four crankshaft rod caps. NOTE: Coat the rear oil seal area and the crankshaft rear oil seal lip with engine oil. NOTE: Make sure the crankshaft rear oil seal is on correctly and that the edges are not rolled over. Using the special tools, install a new crankshaft rear oil seal. NOTE: Install the oil pan within ten minutes after the sealant is applied. Apply silicone gasket and sealant F6AZ-19562-AA or equivalent Ford specification WSE-M4G323-A6 approximately 3 mm (0.125 In) wide at the oil pan to cylinder block joints and the crankshaft rear oil seal retainer to cylinder block joints. • 2002 Focus Workshop Manual Page 4 of 9 17. Install the timing belt guide and the crankshaft sprocket. Install the water pump. Use a new gasket. Ford Focus 2002 2003 - Manual De Reparacion - Repair7, Aprende a reparar tu Ford focus con este manual Original Del Fabricante. Ford Focus 2002 2003 – Manual De Reparacion – Repair7. Ford Focus 2002 2003 - Manual De Reparacion - Repair7 * Price: $17.00. Ford Focus 2002 2003 – Manual. Install the timing belt tensioner. Line up the timing marks of the crankshaft. • 2002 Focus Workshop Manual Page 5 of 9 23. Rotate the crankshaft two turns and recheck the timing marks. Install the upper timing belt cover. Install the timing belt cover. NOTE: Using the special tool, hold the crankshaft pulley. Reparacion Ford Focus MANUAL DE TALLER. Manual De Fiesta Focus MANUAL FORD ECONOLINE E-150-E-450 2001-2002 - Esp, Manuales de Mecanica Reparacion Taller Gratis. Manual De Reparacion Y Despiece De Ford Focus 2 Manual de reparacion ford focus 2002 gratis. SOPORTE DEL MOTOR FORD FOCUS 2002 - Duration:.. Install the crankshaft pulley. • 2002 Focus Workshop Manual Page 6 of 9 30. NOTE: Tighten the bolts evenly. Install the exhaust manifold. Use a new gasket. Install the accessory drive bracket. Install the generator (if necessary). NOTE: Wrap the threads with Teflon® tape. Install the oil pressure sender unit. • 2002 Focus Workshop Manual Page 7 of 9 36. Install the coil bracket, coil and spark plug wires. Connect the spark plug wires. Install a new gasket and the intake manifold. Tighten the nuts and bolts to 10 Nm and 90 degrees. • 2002 Focus Workshop Manual Page 8 of 9 42. Connect the fuel pressure sensor electrical connectors. Connect the oil pressure sender unit and the knock sensor electrical connectors. Connect the idle air control valve and the throttle position sensor. • 2002 Focus Workshop Manual Page 9 of 9 49. Install the EGR tube to the EGR valve. Remove the engine from the stand. Install the flywheel. Tighten the bolts fingertight. Install the special tool. Tighten the bolts. Install the clutch (if equipped). ![]() For additional information, refer to Section 308-01A.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |